The BR-8 receiver Key Features:
SolarBeam™ BR-8 Receiver
The system enables you to connect up to 8 SolarBeams™ to any conventional wired alarm.
Add SolarBeam sensors to any wired alarm system. The sensors send a signal to the SolarBeam BR-8 receiver, which is connected to your existing wired alarm system. The receiver unit is connected to the alarm system in the same way as any other sensor.
The receiver is simple to install. Place it close to the alarm panel, but where it has a clear radio signal from each SolarBeam pair. Run a pair of wires for each alarm output to the alarm panel. The wireless SolarBeam will then activate the alarm in the same way that any other sensor would.
Up to 8 wireless sensors can be registered. Separate output for each sensorAlarm output: NC dry contact; 1A, 120V AC; 2A, 24V DC LEDs indicate the active zone Alarm time: 3 sec Power input: 12V DC Power consumption: stand-by current < 8mA alarm current < 30mA RF frequency: 433MHz RF receiver sensitivity: -105dBm Size: 100 x 68 x 35mm Operating temperature: -25 deg C to 55 deg C
We are able to offer security advice and guidance.
Our license number is 756888